CISCO ASA5505 - No image found error

[M_Roz]

I have ASA5505. This device boot in ROMMON mode with a ''no image found' error. I try the following solution and it works but, every time the device reboot or restarts again it boot in ROMMON mode with the same error. I also try to reset it but the reset button is not working. Does anyone have a solution? 

ADDRESS=192.168.1.11

SERVER=192.168.1.10

GATEWAY=192.168.1.10

IMAGE-asa917-23-k8.bin

PORT=Ethernet 0/0

set

tftpdnld

[balaji.bandi]

When you are in ROMMON mode - can you post below information.

> sh disk0:

> sh flash

also, try the issue command ( and post the output)

>boot 

if the ASA boots post below command output :

# show ver | incl register

If the ASA failed to boot, then you follow below documet 

1. download ASA Image, Copy into TFTP root server and load from TFTP

https://www.networkstraining.com/using-the-rommon-to-load-a-new-image-on-cisco-asa-firewall/

[M_Roz]

rommon #14> sh disk0:
Please define the specific show command.
Valid "show" command arguments are:
"idprom": display ID-PROM Fields
" info": display platform specific information
" gdb": display image gdb settings
" reg": display current TFTP port device registers
" stat": display current TFTP port state and stats

rommon #14> sh flash
Please define the specific show command.
Valid "show" command arguments are:
"idprom": display ID-PROM Fields
" info": display platform specific information
" gdb": display image gdb settings
" reg": display current TFTP port device registers
" stat": display current TFTP port state and stats

rommon #14> boot
Launching BootLoader...
Default configuration file contains 1 entry.

Searching / for images to boot.

No images in /
Error 15: File not found

unable to boot an image

Default configuration file contains 1 entry.

Searching / for images to boot.

No images in /
Error 15: File not found

unable to boot an image

Failsafe booting engaged.
Default configuration file contains 1 entry.

Searching / for images to boot.

No images in /
Error 15: File not found

unable to boot an image

CISCO SYSTEMS
Embedded BIOS Version 1.0(12)6

[balaji.bandi]

Not sure at this stage it was registry issue -

Try boot from TFTP and Format the Flash and copy the image as suggest other post or below one :

https://siavashyousefi.com/cisco-asa-rommon-error-15-file-not-found-unable-to-boot-an-image/