Cisco ASA5545X Startup Error Message

[TW80CJ5]

Hello Everyone!

I am working on an ASA configuration and when I apply it to the ASA and reboot, I get a couple of error messages displayed on the console.

For example, I get the following:

ERROR: specified object Object123 does not exist

*********Output from config line 1509, "access-list OUTSIDE_acce..."

Problem is the CLI is cutting off the rest of the line so I am not sure where to fix the problem. Is there a way to fully display the error message...??

How can I view the full message ???

[balaji.bandi]

ERROR: specified object Object123 does not exist

*********Output from config line 1509, "access-list OUTSIDE_acce..."

you can download the configuration - show run (use notepad++ you can see the Line number associated with the error)

looks some information missing  -Object123

[TW80CJ5]

BB,

I tried that and it still didnt match up the lines that failed. Upon further troubleshooting I discovered the error. I was using "object" instead of "object-group".

Thanks for the help as always!!!!!!!

[balaji.bandi]

Glad you able to find the solution that is bottom...good to know.

[LindaKreyd79899]

It's helps me, thank you.