Cisco Network Assitant

[bhhouston]

I have a number of Catalyst 2950 switches that I manage with the Cisco Network Assistant (v 2.0). I can see all the switches inside the LAN but can't see any switches inside my DMZ or my point of entry switch outside the firewall.

Is there a way to configure my firewall so that I can see these switches with the Network Assistant?

Thanks, Ben

[nhabib]

CNA uses http to connect to the switches

You will need to make sure that none of the http traffic is blocked at the firewall

For additional information regarding firewall, you might want to go to the Security part of NetPro

[diegogonzalezcisco]

necesito el software cisco network assitant pero ya no esta disponible me pueden ayudar por favor

[Georg Pauwen]

Hola,

sabes que el software es antiguo y obsoleto...