06-13-2018 08:05 AM - edited 03-01-2019 06:38 PM
Just installed the evaluation copy of Cisco Prime Infrastructure 3.2. I went through the setup prompts and I can ping the server from my network and from a network stand point it seems good. However I can not web into the system to actually trial this. The troubleshooting guide says to run command 'ncs status' to check the status of the server. However I get the following error.
sh: /opt/CSCOlumos/bin/wcsadmin.sh: No such file or directory
Please advise on how I can get this running.
06-13-2018 08:39 AM
- Can only assume that the install got corrupted for some reason; make sure that you are using a supported/compatible platform (hypervisor/version) (e.g.). And take into account the needed systen resources required too.
M.
06-13-2018 08:42 AM
That's what I would say, too. Are you sure you installed with enough disk space?
06-13-2018 10:32 AM
I meet all the hardware specs as defined by the recommended Express version. Should I do a reinstall?
06-14-2018 09:15 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide