cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1375
Views
0
Helpful
5
Replies
pswinczak
Beginner

Cisco smartports - connection problems

Hello,

I tried to fight with google's but can't resolve a problem.

I've got Cisco swirch with IOS 15.0(2)SE4 and configured a few ports as Cisco Access Point smartports. AP's connected to that ports works only with that setting. Case is that I even can't ping AP's under its IP address. If I change the setting i.e. to Desktop I can work with AP but there is no internet connection on WiFi

Please help... I would like to monitor AP's with SNMP.

My target is to connect with Cisco Access Points with appropriate smartports settings.

Regards,

Pawel

5 REPLIES 5
Leo Laohoo
VIP Community Legend

Move this thread to "EEM".

pswinczak
Beginner

As an addition. It's my port conf:

interface GigabitEthernet0/6

switchport trunk encapsulation dot1q

switchport trunk native vlan 2

switchport mode trunk

switchport nonegotiate

srr-queue bandwidth share 1 30 35 5

priority-queue out

mls qos trust cos

macro description cisco-wireless

auto qos trust

spanning-tree bpduguard enable

Nobody knows an answer?

Leo Laohoo
VIP Community Legend

Pawel,

There is only one in-house expert in regards to EEM.  He's not there for your Beck and call.  You need to be patient or you can contact TAC (your case will still go to him).

Leo,

I did not knew that, so take my apologise.