03-27-2013 09:31 AM
I try to add a Catalyst 2960 to Cisco Network Assistant, I get the prompt for password but I get a "Authentication failed". I use the same login / password for telnet that works fine. Http admin page is reachable but I cannot login with the "admin" account...
Show run says :
ip http server
ip http secure-server
Any tips ?
Config file attached...
Thanks
Solved! Go to Solution.
03-27-2013 12:21 PM
Try adding "ip http authentication local"
03-27-2013 12:21 PM
Try adding "ip http authentication local"
03-28-2013 02:31 AM
It works !!!
Thank you for your help Marvin !
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: