Network Management

Hi gents, Subject tells it all more lessI have a Cat3750, which, after erase nvram and reload will boot into defaults andI would like to give him configuration (run the script)And I was thinking about triggering (how?) the script based on...something...

Hi all,Has anyone had an issue adding a 4402 to their NCS? It is listed under the supported devices, however my NCS install always seems to throw it in the Unknown devices stating that it is an Unsupported device.

How do I go about ordering the Compliance licencse with the Prime appliance?thanks much,Mark

Has any one identified a way to run a report in Cisco LMS Prime 4.1 to report if switchports have port-security and Sticky-mac enabled?

We are trying to turn on out fault notifications and are having issues with the threshold settings. We changed the interface utilization to 80% instead of 40% buy it is still alerting us at 40%. I have applied the setting to all interface groups/type...

Dear AllI am getting following messages on Cisco prime LMS.These errors are generating in LMS for the different ports of the folloiwng modules of Cat 65131) WS-X6708-10GE2) WS-Sup720-10GE3) WS-X6748-GE-TXOutOfRange::Component=VOLT-10.x.x.x/11067 [Te2...

Hi every oneI have a doubt. how to add a device to an SNMP community?. I mean the community already exists and it is already monitorizing by a PC (monitoring tests are performed in implemantacion possible).  and there are several teams that are monit...

Platform: LMS 3.2.1 with RME 4.3.2 on Windows 2003I'm having a problem with several devices that were backing up fine until this week - suddenly they aren't backing up their running configurations, but RME is fetching their startup configurations fin...

i have installed lms 4.2.2 fot testing purpose i can do inventory and other functions but i cant get fault event and fault monitor alert.

ospf , webserver cant access from host while both host can ping it... it gives server reset connection message when try to access .(fa0/0 webserver conct)ip dhcp excluded-address 192.168.10.1ip dhcp excluded-address 192.168.1.1!ip dhcp pool shah netw...