12-29-2010 03:37 AM
Hi
Using LMS 3.2 RME 4.3.0. I'm trying to deploy baseline config after compliance check. When I select compliance check job and click deploy i got this error:
"DCMA0058: Could not deploy selected Job.
No compliance report available."
But the report in baseline jobs window i available.
Any ideas what should i check ??
Solved! Go to Solution.
12-29-2010 11:32 PM
Please run a device update from Common Services --> Software Center --> Device Update --> Select RME under products and check for updates from Cisco.com and install all the device packages.
Duplicate the problem again after update and post the error if it appears again.
12-29-2010 11:32 PM
Please run a device update from Common Services --> Software Center --> Device Update --> Select RME under products and check for updates from Cisco.com and install all the device packages.
Duplicate the problem again after update and post the error if it appears again.
12-30-2010 02:31 AM
Thanks a lot. Seams to work for me.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: