So, I didn't think this was going to be a big issue, assign the VLAN 66 which is used all over in our network to this port and wa-la, it's good to go. But....no. The switch is part of a stackable (3) 9200L, it's not going out anywhere, the interface goes just to a wall port, but even it it were, VLAN 66 is on the trunk port as well.
switchport trunk allowed vlan 3,10,11,31,50,66,72,95,100,137-151,201,209,210
Switch int config:
interface GigabitEthernet3/0/27
description camera
switchport access vlan 66
switchport mode access
switchport voice vlan 238
spanning-tree portfast
#sh vlan id 66
66 PSN-Cameras active Gi1/0/25, Gi1/0/26, Gi1/0/27, Gi3/0/27
If you need more info, please tell me what you need.
I'm seeing APIPA and not DHCP for some reason. Any ideas on why this would be?
