cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
207
Views
5
Helpful
3
Replies

Configured VLAN on interface but not not getting DHCP to assign IP

JWHolm81891
Beginner
Beginner

So, I didn't think this was going to be a big issue, assign the VLAN 66 which is used all over in our network to this port and wa-la, it's good to go. But....no. The switch is part of a stackable (3) 9200L, it's not going out anywhere, the interface goes just to a wall port, but even it it were, VLAN 66 is on the trunk port as well. 

switchport trunk allowed vlan 3,10,11,31,50,66,72,95,100,137-151,201,209,210

Switch int config:

interface GigabitEthernet3/0/27
description camera
switchport access vlan 66
switchport mode access
switchport voice vlan 238
spanning-tree portfast

#sh vlan id 66

66 PSN-Cameras active Gi1/0/25, Gi1/0/26, Gi1/0/27, Gi3/0/27

If you need more info, please tell me what you need.

 

I'm seeing APIPA and not DHCP for some reason. Any ideas on why this would be?

 

 

 

3 Replies 3

MHM Cisco World
Advisor
Advisor

we need more elaborate 

MHM Cisco World
Advisor
Advisor

run CDP to make SW detect if device is Phone or PC.

MrButton
Beginner
Beginner

Do a sh run int vl 66

do you have an ip helper-address DHCPServer_IP

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers