03-05-2020 07:02 AM
Beginner.............
I have found myself supporting a network within a private MPLS network. VRFs are configured and I have worked out how they operate at Layer 3 ie., VLAN interface and its routing information within each VRF as necessary, including a management vlan within one VRF on the core switch. Routing is working all good via OSPF > BGP and has been for sometime across our existing network....happy days! I now have an unused ASR1001 - X not on the network (yet), but has its gigabitethernet0 (mgmt-intf) only connected to a port on the core switch. The port on the core switch is in the right vlan for mgmt and VRF is assigned to it.
My question is : How do I configure the ASR1001-x mgmt-interface....so that it can be communicated to via the core switch. I have ., given the mgmt interface an iP address on the ASR1001-x, in the same management vlan as the core switch, and maybe overthinking it, but the routing confuses me a little , due to the VRF back on the core switch. Any advice appreciated! thanks
Solved! Go to Solution.
03-05-2020 07:30 AM
if the Core Switch has Right VLAN, configured ASR MGMT VRF with IP address of MGMT range, you should be able to connect to that device.
is that make sense ?
03-05-2020 07:30 AM
if the Core Switch has Right VLAN, configured ASR MGMT VRF with IP address of MGMT range, you should be able to connect to that device.
is that make sense ?
05-12-2020 11:31 AM
Hi, sorry to take so long to reply to your advice. It worked, Thankyou ....had to move on to other work due to Covid-19.
Stay safe!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide