cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
384
Views
1
Helpful
5
Replies

Deny inbound icmp src JCEL: [destination address] dest Inside: [dest.

DSterling
Level 1
Level 1

Switch 1 is connected to the inside interface of the ASA with a permit any any on the inside interface and switch 2 is connected to the outside 2 with permit any any on the outside interface. Routing is set up on the switches and I'm getting Deny inbound icmp src JCEL: [destination address] dest Inside: [dest. IP] (type 8, code 0)

ICMP is being allowed in the Service Policy Rules

Thank you,

Dave

1 Accepted Solution

Accepted Solutions

Yes they were both 100, change the new interface to 25 and now it works. 

View solution in original post

5 Replies 5

Did you add icmp inspect ?

MHM

Yes, I have added ICMP to the Service Policy Rules 

both have same security level?

MHM

Yes they were both 100, change the new interface to 25 and now it works. 

You are welcome 
MHM

Review Cisco Networking for a $25 gift card