We are running into a slight problem with the action mail command on equipment at a specific location. The mail server our routers are using requires smtp authentication. Unfortunately, the username for each node is using a email@example.com naming convention. Regrettably this naming convention is unchangeable for the time being. The issue we are experiencing is the syntax used with EEM for mail authentication is either serverusername@host or serverusername:password@host. Because we must use the '@' symbol in our username, it seems that EEM is interpreting this as both the 'username' and 'host' values. I've toyed with this a few different ways and haven't found a workaround just yet. Any suggestions?