Error: Can not Configure Port Security Because Dynamic Port
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-28-2009 04:16 AM
Hello
I'm using to manage network CiscoWorks version 3.0.
I installed the cisco view (6.1.7) for managing by gui the switches campus.
On some of My IOS switches I encountered this kind of problem while,by cisco view, I try to change the configuration of port security (Error: Can not Configure Port Security Because Dynamic Port). I checked all the configurations on this switches and I'm sure that the ports are not in dynamic mode and there are not channel configured on that. So at the end I can't manage this error, please let me know if you have suggestions to give me.
Thanks so much in advance
- Labels:
-
Network Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-25-2018 05:00 AM
I too had that same issue, when I was trying to config an interface to use port-security.
Problem:
#switchport port-security
Command rejected: GigabitEthernet1/0/8 is a dynamic port.
Solution:
#switchport mode access
and then you can add the port-security.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-14-2020 12:27 PM
thank you !!!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-25-2021 09:11 PM
thanks very much
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-27-2021 04:55 AM
Thank you so much
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-05-2022 09:14 AM
Very helpful
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2022 07:48 PM
Thank you for the solution. I appreciate it. DNA HRBlock
