cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1916
Views
5
Helpful
2
Replies

Help with Mac Filtering using Aironet 1830 Cisco Mobility Express

hoosier2933
Beginner
Beginner

Hello,
Im working on getting a cisco aironet 1830 controller/acces point ready to drop in on our network. In the past ive used standalone 1600's where I was able to configure mac filtering and apply those filters to particular vlans. I dont see this option in the cisco mobililty express gui, and was hoping someone may be able to get me out. I need to be able to only allow certain users to connect to certain wlans. Problem is i give the key to one person who I would like to allow, and then that key gets password around to other users who I dont want to be able to connect to that wlan. I see there is a firewall option within the mobility express controller, but not sure if thats going to accomplish what i need or not. Thanks in advance for any help on this.

1 Accepted Solution

Accepted Solutions

JASON VLAD
Beginner
Beginner

I know its an old thread but in case someone runs across this link... take a look at this link. CLI supported but GUI supported in 8.4 which will be release in March give or take.

https://supportforums.cisco.com/discussion/13025671/mac-filtering-wireless-mobility-express

View solution in original post

2 Replies 2

JASON VLAD
Beginner
Beginner

I know its an old thread but in case someone runs across this link... take a look at this link. CLI supported but GUI supported in 8.4 which will be release in March give or take.

https://supportforums.cisco.com/discussion/13025671/mac-filtering-wireless-mobility-express

Thank you for your reply, I did find the cli command options awhile back and was able to get working. Good to know they've got some more gui options coming in later releases.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: