01-30-2017 06:56 PM
HI Team,
Could you help to advice configuration for enabling Netflow?
Attached the show run file..
01-30-2017 10:18 PM
Check out this guide on migrating to flexible netflow.
http://docwiki.cisco.com/wiki/Migrating_from_Traditional_to_Flexible_NetFlow
01-31-2017 08:15 AM
Hi
Heres a working one off my 4331s that will work on 4551 , you will need to tweak the ip etc
flow record FLOW-RECORD
description record to monitor network traffic
match ipv4 tos
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
match transport source-port
match transport destination-port
match interface input
match interface output
collect routing source as
collect routing destination as
collect routing next-hop address ipv4
collect transport tcp flags
collect counter bytes
collect counter packets
collect timestamp sys-uptime first
collect timestamp sys-uptime last
!
!
flow exporter NetQos
description export Netflow traffic to HQ
destination x.x.x.x
source Loopback3
template data timeout 300
option interface-table timeout 1000
option exporter-stats timeout 1000
!
!
flow monitor xilinx_nq
description Used for ipv4 traffic analysis (Mapped To FLOW-RECORD)
record FLOW-RECORD
exporter NetQos
statistics packet protocol
The under your L3 interfaes you want to collect the flow from
Interface x/x
ip flow monitor xilinx_nq input
ip flow monitor xilinx_nq output
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide