I need help to interpret a portion of Client Session report in Prime Infrastructure. I placed a call with TAC and the engineer was unable to explain what the output means (for which I am si disappointed)
Avg. Session Throughput(Kbps)
2015-Nov-29, 12:38:43 EST
I'd like to know what it means when the device is showing an SNR of 0 and an RSSI of -128. Technically the device should be unreachable on the network, however my monitoring tool doesn't show it as down! So the device is reachable but the RSSI is -128! It doesn't make sense to me!
And also, session duration is 40 min 2 sec, doesn that mean during 40 minutes the RSSI was -128? Or this value is just a sample?
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...