04-28-2019 10:48 PM
Dear Members,
I have configured SNMP Protocol at Router1 and Router 2 ( Connected on Serial Interface). I am collecting data for my PRTG monitoring tool from SNMP trap config at R1 and R2. I would like to config now IP SLA and Netflow v9 or v5 at Cisco router so that I can gather data at my PRTG Probe. The main reason is to monitor Delay, Latency and Packet Loss for UDP Traffic. Please help me to configure. Thank You
04-29-2019 02:56 AM
04-29-2019 03:54 AM
Hi
I haven't started as didn't get any clear details to config and linked it to PRTG. Can you help me please. Below is my network.
PC1 --Fast Ethernet--- > Router 1(192.168.10.2) --Serial-- > Router 2 (192.168.10.4) --F.Ethernet-- > PC2 ( PRTG)
Thanks
04-29-2019 04:36 AM
04-29-2019 04:44 AM
Great Thanks, Let me do it tomorrow at Lab. I will update you. Appreciate your reply :-)
04-30-2019 12:13 AM
Hello
I have config it at Routers and but it show Grey at PRTG. I am figuring out the issue at PRTG. Meanwhile i have two question
1. Will NetFlow Provide me the delay and packet loss parameters ? or IP SLA is better ?
2. I have already configured SNMP Trap at routers and getting proper data at PRTG. Can all these run in parallel or should be only one ?
Thank You
04-30-2019 12:53 AM
04-30-2019 08:58 AM
Thank You
Can you please also advise on IP SLA steps as well ? I appreciate.
04-30-2019 12:50 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide