Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
782
Views
0
Helpful
8
Replies

line protocol up down

Go to solution
nijamudeen_aziz
Level 1
Level 1

‎11-03-2022 03:45 AM

trunk link between two switches line protocol up and down fluctuating

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Georg Pauwen
VIP
VIP
In response to nijamudeen_aziz

‎11-09-2022 05:46 AM

Hello,

you could be hitting the cosmetic bug below:

3650/3850 :: Crashinfo: filesystem high utilization with only default traces enabled
CSCvc14038
Customer Visible
Notifications
Save Bug
Open Support Case
Description
Symptom:
WS-C3650-12X48UQ switch might report a syslog about crashinfo: filesystem utilization exceeding 80%:

%PLATFORM-4-ELEMENT_WARNING:Switch 1 R0/0: smand: 1/RP/0: limited space - copy corefiles/switch-reports out of flash:core & crashinfo: directories. crashinfo: value 82% (118 MB) exceeds warning level 80% (116 MB)

Conditions:
Just default traces enabled.

The error message is cleared when the files are automatcally rotated:
%PLATFORM-4-ELEMENT_WARNING:Switch 1 R0/0: smand: 1/RP/0: crashinfo: usage has returned to appropriate level. value 36% (52 MB) is below warning level 80% (116 MB)

However the problem periodically comes back as the amount of traces gather increases (until they are again rotated).
The issue seems to arise from the fact that the switch has much smaller size of crashinfo: filesystem - 148MB comparing to other 3650 switches (eg. WS-C3650-48P) - 250MB

Workaround:
Configure Syslog Discriminator:

logging discriminator HIDE_LOG severity drops 4 facility drops PLATFORM mnemonics drops ELEMENT_WARNING
logging buffered discriminator HIDE_LOG 100000
logging console discriminator HIDE_LOG
logging monitor discriminator HIDE_LOG

View solution in original post

0 Helpful
8 Replies 8

Go to solution
nijamudeen_aziz
Level 1
Level 1

‎11-03-2022 03:47 AM

log attached

Preview file
5 KB
0 Helpful

Go to solution
pieterh
VIP
VIP

‎11-03-2022 06:14 AM

1) collect the same information from the connected switch (the coreswitch?)
2)3650# 3650#sh interfaces tenGigabitEthernet 1/1/3 switchport ...
Negotiation of Trunking: On-> you may want to disable negotiation 

0 Helpful

Go to solution
nijamudeen_aziz
Level 1
Level 1
In response to pieterh

‎11-09-2022 05:26 AM

Core#sh int te
Core#sh int tenGigabitEthernet 4/0/1 swi
Core#sh int tenGigabitEthernet 4/0/1 switchport
Name: Te4/0/1
Switchport: Enabled
Administrative Mode: trunk
Operational Mode: trunk
Administrative Trunking Encapsulation: dot1q
Operational Trunking Encapsulation: dot1q
Negotiation of Trunking: On
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 1 (default)
Administrative Native VLAN tagging: enabled
Voice VLAN: none
Administrative private-vlan host-association: none
Administrative private-vlan mapping: none
Administrative private-vlan trunk native VLAN: none
Administrative private-vlan trunk Native VLAN tagging: enabled
Administrative private-vlan trunk encapsulation: dot1q
Administrative private-vlan trunk normal VLANs: none
Administrative private-vlan trunk associations: none
Administrative private-vlan trunk mappings: none
Operational private-vlan: none
Trunking VLANs Enabled: ALL
Pruning VLANs Enabled: 2-1001
Capture Mode Disabled
Capture VLANs Allowed: ALL

Protected: false
Unknown unicast blocked: disabled
Unknown multicast blocked: disabled
Appliance trust: none
Core#

***both side trunk negotiation is On ,

0 Helpful

Go to solution
nijamudeen_aziz
Level 1
Level 1

‎11-09-2022 05:27 AM

Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_LOCAL: Blocking TenGigabitEthernet4/0/1 on VLAN0001. Inconsistent local vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0008. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0011. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0016. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0021. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0025. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0026. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0034. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0116. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0201. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0202. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0203. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0204. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0205. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0206. Inconsistent peer vlan.
.Nov 8 05:58:00: %SPANTREE-2-BLOCK_PVID_PEER: Blocking TenGigabitEthernet4/0/1 on VLAN0210. Inconsistent peer vlan.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0005. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0008. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0011. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0016. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0021. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0025. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0026. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0034. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0116. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0201. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0202. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0203. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0001. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0204. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0205. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0206. Port consistency restored.
.Nov 8 05:58:15: %SPANTREE-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet4/0/1 on VLAN0210. Port consistency restored.

 

this log in Core switch. when link is up down

0 Helpful

Go to solution
nijamudeen_aziz
Level 1
Level 1

‎11-09-2022 05:29 AM

*Nov 9 08:05:16: %PLATFORM-4-ELEMENT_WARNING:Switch 1 R0/0: smand: 1/RP/0: limited space - copy corefiles/switch-reports out of flash:core & crashinfo: directories. flash:core value 7% (112 MB) exceeds warning level 5% (79 MB)

 

 

getting this message in 3650#

0 Helpful

Go to solution
Georg Pauwen
VIP
VIP
In response to nijamudeen_aziz

‎11-09-2022 05:46 AM

Hello,

you could be hitting the cosmetic bug below:

3650/3850 :: Crashinfo: filesystem high utilization with only default traces enabled
CSCvc14038
Customer Visible
Notifications
Save Bug
Open Support Case
Description
Symptom:
WS-C3650-12X48UQ switch might report a syslog about crashinfo: filesystem utilization exceeding 80%:

%PLATFORM-4-ELEMENT_WARNING:Switch 1 R0/0: smand: 1/RP/0: limited space - copy corefiles/switch-reports out of flash:core & crashinfo: directories. crashinfo: value 82% (118 MB) exceeds warning level 80% (116 MB)

Conditions:
Just default traces enabled.

The error message is cleared when the files are automatcally rotated:
%PLATFORM-4-ELEMENT_WARNING:Switch 1 R0/0: smand: 1/RP/0: crashinfo: usage has returned to appropriate level. value 36% (52 MB) is below warning level 80% (116 MB)

However the problem periodically comes back as the amount of traces gather increases (until they are again rotated).
The issue seems to arise from the fact that the switch has much smaller size of crashinfo: filesystem - 148MB comparing to other 3650 switches (eg. WS-C3650-48P) - 250MB

Workaround:
Configure Syslog Discriminator:

logging discriminator HIDE_LOG severity drops 4 facility drops PLATFORM mnemonics drops ELEMENT_WARNING
logging buffered discriminator HIDE_LOG 100000
logging console discriminator HIDE_LOG
logging monitor discriminator HIDE_LOG

0 Helpful

Go to solution
nijamudeen_aziz
Level 1
Level 1

‎11-09-2022 09:05 PM

how to resolve this issue. have to contact cisco tech support or upgrade this IOS firmware

0 Helpful

Go to solution
nijamudeen_aziz
Level 1
Level 1

‎11-10-2022 02:52 AM

current switch version WS-C3650-48PD 16.3.5b CAT3K_CAA-UNIVERSALK9 INSTALL,

can we update to 16.12.7(MD) directly 

0 Helpful
Customers Also Viewed These Support Documents