09-05-2013 07:15 AM
Hello Everyone,
"CM051 Vlan Running Config Fetch Failed For x.x.x.x Cause:Command FailedTelnet:Failed to establish telnet connection to x.x.x.x-cause connection refused.
Vlan config job not supported using TFTP
Vlan config job not supported using SCP"
I am getting this error while running sync archive job. While fetching configuration LMS tries using Telnet and TFTP. How can i make it to SSH and TFTP..?
Where i should configure in LMS..?
KVS
09-05-2013 07:57 AM
here you can define the transport protocols:
RME > Administration > Config Mgmt > Transport Settings
be aware that you can define these settings for the different applications from the drop-down box (i.e. Archive Management, Config Editor, and NetConfig) and that the protocols choosen will be tried from top down if one fails.
see the user guide for details:
09-05-2013 09:49 PM
Thanks for your reply.
If i create sync archive job, the job fails but config is archived for the same device.. what could be the reason..?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: