LMS 4.2.3 Fault Monitor threshold question

[cwallin]

Hello, I would like to know if anyone know how to find out which Fault Threshold group a specific interface belongs to.

The scenario is that in Fault Manager there is an alarm for which I want to change the Threshold Setting.

Example Alarm:

Event_Description HighUtilization

Device IP x.x.x.x

Device Type Routers

Fault Last Updated At 19-Mar-2013 09:44:25

Component IF-router2.x.x/26 [Tu187] [x.x.x.x]

Component Class Interface

Component Event Code 1056

Current Utilization 68.323204 %

Duplex Mode FULLDUPLEX

Event Category Utilization

Event Source DFM

If Description Tunnel187

Max Speed 100000

Traffic Rate 8540.4 BYPS

Type TUNNEL

Utilization Threshold 40

If I look in Monitor > Fault  Settings > Setup > Threshold  Settings.

Then expand all groups under DFM, there is no group called "Tunnel", so the question is which group this Interface belongs to?

BR /Crille

[Nael Mohammad]

Its defined as an 10/100 ethernet interface " Component Class Interface"  with a 40% threshold utilization which it fell below per the event notifiation of 68.3%.

Component IF-router2.x.x/26 [Tu187] [x.x.x.x]

If Description Tunnel187 --> Interface on router

Max Speed 100000 --> Interface type(Fast Ethernet)