Hello, I got some questions about Performace Reports, more specifically "Interface utilization".
If I use the Report -> Performance -> Interface -> Utilization and select one device it generates a report with 3 Interfaces, Fa0/4, Gi0/2 and Fa0 from that device.
The device Interface status is:
Fa0/1 connected trunk a-full a-100 10/100BaseTX
Fa0/2 connected trunk a-full a-100 10/100BaseTX
Fa0/3 disabled 1 auto auto 10/100BaseTX
Fa0/4 connected trunk full 100 10/100BaseTX
Fa0/5 disabled 1 auto auto 10/100BaseTX
all interfaces in between are disabled also
Fa0/24 disabled 1 auto auto 10/100BaseTX
Gi0/1 connected trunk full 1000 1000BaseLX
Gi0/2 connected trunk a-full a-1000 10/100/1000BaseTX
Fa0 connected routed a-full a-100 10/100BaseTX
The logical (for me) would be that all connected interfaces (Fa0/1,Fa0/2,Fa0/4,Gi0/1,Gi0/2,Fa0) would be included in the report.
To the qeustions:
How can I make all connected interfaces appear in the report?
Is there any way to make a report on for a specific interface, say Fa0/1?