From the various posts around here, I read that, in Config Mgmt, LMS connects through Telnet or SSH to devices, then uses TFTP to send configs.
In my network, I run SSH on my devices. Device Credentials Verification Job is successful for sw1 and sw2, which by the way are Catalyst 4948. However, in Config Mgmt, they are displayed as Partially Successful.
I wanted to test manually by connecting to the device through SSH then issuing TFTP copy. I found that "vlan.dat" is not under Flash; it's under Cat4000_flash.
So how do I tell LMS to fetch under Cat4000_flash instead of Flash, for this model of switches?
Starting from NFVIS 3.12 versions, the deploy option does not depict all the SR-IOV VFs(Virtual Functions) available in a physical interface. This change is introduced as (i) the number of VFs of ENCS platform on LANs side is increased to 24 and (ii) the...
Community Live- Getting to know Cisco SD-WAN
(Live event - formerly known as Webcast- Wednesday December 11, 2019 at 10 am Pacific/ 1 pm Eastern / 7 pm Paris)
This event will have place on Wednesday 11th, December 2019 at 10hrs PDT
Hi alli have 40 spots (40 Ethernet cables for computers coming out from switch) and i want each of these spots to have fix IP which means if i swap the computer the IP of certain spot remain the same.example : at spot 30 i have IP address of 192.168.22.40...
Cisco DNA Center nodes lost network connectivity. Cannot SSH to nodes. Cluster and Enterprise port connected to Cisco Nexus Switches.
Cisco DNA Center kernel logs showing hung queue error messages. "sudo cat /var/log/kern.log"