Hi, i have 2960 Catalyst with LANLITE. And i cannot set "transport input ssh", it allows only telnet. I'm wondering if cisco lanlite switches have ssh input in newer releases of IOS or there is no way to make ssh input on this switch?
Here's show ver output (i removed all serial and part numbers):
S14#sh ver
Cisco IOS Software, C2960 Software (C2960-LANLITE-M), Version 12.2(37)EY, RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Thu 28-Jun-07 18:07 by antonino
Image text-base: 0x00003000, data-base: 0x00D00000
ROM: Bootstrap program is C2960 boot loader
BOOTLDR: C2960 Boot Loader (C2960-HBOOT-M) Version 12.2(37r)EY, RELEASE SOFTWARE (fc1)
S14 uptime is 17 weeks, 1 day, 47 minutes
System returned to ROM by power-on
System restarted at 10:49:35 UA Thu Apr 28 2011
System image file is "flash:c2960-lanlite-mz.122-37.EY/c2960-lanlite-mz.122-37.EY.bin"
cisco WS-C2960-48TC-S (PowerPC405) processor (revision A0) with 61440K/4088K bytes of memory.
Processor board ID
Last reset from power-on
2 Virtual Ethernet interfaces
48 FastEthernet interfaces
2 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
64K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 00:1F:C9:7E:A6:00
Motherboard assembly number :
Power supply part number :
Motherboard serial number :
Power supply serial number :
Model revision number : A0
Motherboard revision number : A0
Model number : WS-C2960-48TC-S
System serial number :
Top Assembly Part Number :
Top Assembly Revision Number : A0
Version ID : V01
