1889
Views
0
Helpful
1
Replies
MIB for CRC errors
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-29-2014 08:24 AM
Hello, I have a client that is wanting to monitor CRC errors on a router's WAN interface. The client was attempting to use the ETHERLIKE-MIB, but this will not work. I was looking at the following:
This is for the IF-MIB and specifically the ifInErrors from the OID tree. I just wanted to see if I could get your opinion on this and if you have any suggestions, I would be very grateful for your time and input.
Labels:
- Labels:
-
Network Management
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-03-2015 02:27 PM
This discussion has been reposted from Additional Communities to the Network Management community.
