we have LMS 3.1, we have configure MODULE LEVEL ALERTS in DFM for 6500 switch Modules.
after configure the same, we got alreats for Module down, but for module up we are not getting any alerts.
Kindly confirm, how can we configure this to get module level alerts for both up and down.
Solved! Go to Solution.
we have 6509 at customer end and we have inatalled new ws-x6748-ge-tx module in the chassis. erlier we have not configure the module level alrerts in LMS 3.1.
Now customer wants to configure this service iin LMS so he get the module level alerts also along with port & Interface level alerts.
so we have configure the command snmp-server enable traps module at Switch end and after configure this command we got module level alerts when module goes down, but when module comes up we have not recd any alert notification for same.
kindly confirm can we configure the same.
Thanx for your prompt response.
We have done below configration at LMS end but we have not recd E-mail notification when module goes down and up.
Trap Subscription Summary: Edit
Subscription Name: Module
Notification Group: MODULESALERT
Recipient(s): Hostname Port Comments
GUR-SC01.quest.com 162 Snmp-on-18-01-2010
GUR-SC02.quest.com 162 Snmp-on-18-01-2010
We are getting alrerts and mail when any module goes down, but we have not recv any alerts & mails when the module comes up.
You need to check the boxes for Cleared and Informational under the Events section. You should then get notifications when the modules come back up.