11-04-2018 12:53 PM
hello all
i have 3 internet connections and i have a 4331 as my router and i have a 3850 as my switch i have connected my internets to my switch and gave them each there own vlan 500,501,502 and connected my switch to my router via a trunk link with allows only said VLANs and i have created 3 subinterfaces with the same VLANs on each and configured 3 dialer interfaces but my issue is only one comes up the other two keep restarting how can i fix this issue ?
this is my switch:
interface GigabitEthernet1/0/37 switchport access vlan 500 switchport mode access switchport nonegotiate ! interface GigabitEthernet1/0/38 switchport access vlan 501 switchport mode access switchport nonegotiate ! interface GigabitEthernet1/0/39 switchport access vlan 502 switchport mode access switchport nonegotiate ! ! interface GigabitEthernet1/0/42 switchport trunk allowed vlan 500-502 switchport mode trunk switchport nonegotiate speed 1000 duplex full !
this is my router :
interface GigabitEthernet0/0/1 no ip address negotiation auto ! interface GigabitEthernet0/0/1.500 encapsulation dot1Q 500 pppoe enable group global pppoe-client dial-pool-number 1 ! interface GigabitEthernet0/0/1.501 encapsulation dot1Q 501 pppoe enable group global pppoe-client dial-pool-number 2 ! interface GigabitEthernet0/0/1.502 encapsulation dot1Q 502 pppoe enable group global pppoe-client dial-pool-number 4 ! ! interface Dialer1 ip address negotiated ip nat outside encapsulation ppp ip tcp adjust-mss 1452 load-interval 30 dialer pool 1 dialer-group 1 ppp authentication chap pap callin ppp chap hostname **** ppp chap password 0 **** ppp pap sent-username **** password 0 **** no cdp enable ! interface Dialer2 ip address negotiated ip nat outside encapsulation ppp ip tcp adjust-mss 1452 shutdown dialer pool 2 ppp authentication pap chap callin ppp chap hostname **** ppp chap password 0 **** ppp pap sent-username *** password 0 **** ! interface Dialer4 ip address negotiated ip nat outside encapsulation ppp ip tcp adjust-mss 1452 shutdown dialer pool 4 dialer-group 4 ppp authentication pap chap callin ppp chap hostname *** ppp chap password 0 *** ppp pap sent-username *** password 0 *** !
can any one help me on this
11-04-2018 07:19 PM
Hi,
I can see that Dialer 2 and 4 are forced to shut down using the "Shutdown" command.
interface Dialer2 ip address negotiated ip nat outside encapsulation ppp ip tcp adjust-mss 1452 no shutdown dialer pool 2 ppp authentication pap chap callin ppp chap hostname **** ppp chap password 0 **** ppp pap sent-username *** password 0 **** ! interface Dialer4 ip address negotiated ip nat outside encapsulation ppp ip tcp adjust-mss 1452 no shutdown dialer pool 4 dialer-group 4 ppp authentication pap chap callin ppp chap hostname *** ppp chap password 0 *** ppp pap sent-username *** password 0 *** !
Run above-highlighted commands under each dialer interface.
Regards,
Deepak Kumar
11-04-2018 11:05 PM
thanks but the issue continues i have shut them down so my primary connection stays up
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide