Netflow Export Problem
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-24-2005 11:36 AM
I am experiencing a problem exporting netflow packets to a
network management server. The network management server resides behind a
interface on the router that is located in a MPLS VRF. I configured "ip
flow-export destination <server ip> and ip flow-export source G0/0 (the
interface in the MPLS VRF) but receive the following error when debugging ip
flow export: "Sending export pak to <netman ip address> port 9996.
Error sending export packet: Enqueued to process level". I am required
to export version 5 packets. All other routers that export out their interface
located in the global routing table do not experience this problem. Has anybody seen this before? Thanks.
- Labels:
-
Network Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-05-2005 12:31 AM
Have you tried exporting the data from a Loopback address? This has the advantage of data still being sent even if an interface may be down (alternate routing being available).
