Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco Support,We recently swapped out 1GB interfaces in our ESX server and replaced them w/10GB cards. When we did that, the interface IDs presented to the 1000v changed. References to the removed interfaces still appeared when the "show port-chann...
I am trying to create a very basic template in compliance manager that checks for interfaces that aren't members of specific VLANs. VLAN 10 being one of them. I want to match interfaces assigned to VLAN 20. According to the documentation I have rea...
All,I should definitely preface this post by saying I am not by an stretch of the imagination an ASA guy...Does anyone know of a method to determine the maximum number of concurrently used SSL VPN licenses (sessions) on an ASA5540 over a period of ti...
All, I am trying to setup a very basic VPN solution with my PIX 515 version 6.3 at home. As of right now I can successfully connect from the client and can pass traffic through the VPN to inside hosts (i.e. ping), and the hosts respond (both direct...
Can somebody confirm that IP SLA functionality exists on a 4948 switch running 12.2(50)SG3 Enterprise? The feature navigator shows it in there, and the release notes for the 4500 chassis says it is supported, but I am having trouble finding document...
I figured it out and am posting the solution for the benefit of the community.The following verbiage in the following Cisco document appears to be incorrect:"The preceding template command provides a strict matching. However, you could use a range ...
I don't have an answer for you, but would like to share your pain. I wish DISA would spend the time to document this stuff on the most common platforms for the benefit of the people that are having to implement. Would save a lot of people a lot of...
I figured out what I was doing wrong, but I am not 100% sure what the issue is. I had the VPN DHCP pool on the same subnet as the inside interface of the PIX (not a separate subnet). Once I changed the subnet to something different (same as the con...
Yes...sorry....I did get this working. If you configure the AAA authentication line with the tacacs option, but omit the "local" parameter, you will achieve your desired results - localmauthentican will work only if tactics fails. Not sure if this ...
