Platform

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-12-2016 05:01 AM
Hi,
Any one can advice me how i can using ICMP-Jitter ? also in which platform can run this .. Thanks in advance
Kind Regards,
- Labels:
-
Network Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-12-2016 05:51 AM
Hi
you would use it when using ip sla , ip sla can be used for failover reasons or for testing jitter on voice vlans and phones etc , its powerful feature when used right even works with http as well
Itrs not platform dependent but more software you need at least a routing image like ipbase to run it sometimes ipservices
here is the link how to
http://www.cisco.com/c/en/us/td/docs/ios/12_4t/12_4t11/hticmpjt.html
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-12-2016 08:23 AM
Thanks .. So what is the diffrence between ( ip sla monitor ) and ( ip sla ) ? .. Thanks in advance
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-12-2016 08:31 AM
Thats the same feature , you can have just on one side ip sla monitor responder which can be the device does not support full sla configuration as the source of the sla but will respond with stats for the ip sla on far end
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-12-2016 08:52 AM
This mean in IP SLA monitor .. I need to have ip sla responder ? .... Look I need to monitor the Packet loss in my network for multi hop .. to check the performance for my network .. So which IP SLA you recommend to do this that support not only cisco device .. Thanks in advance
