11-24-2014 04:03 AM
Dear All,
Is it possible to extract the reports of client count per ap based on ssid..?
Like, AP Name (eg., 2ndFloorAP) --> SSID (Test)--> Client count for past 1day, 1 week, 1 month etc.
As of now i could see overall client count of an ap from prime not based on SSID (under device work center --> unified ap --> client over time --> client count on ap / client traffic on ap)
11-26-2014 07:59 AM
Prasan,
The closest that Prime has for reporting outside of checking under device work center is under the report launch pad. Report > Report Launch Pad > Client > Client Count, where you can break down the report based on SSID. There are several options available on how to generate like report "AP by floor area" where you can break down associated and authenticated counts. You might be able to drill down further in this section to meet what specifics you are looking for. Hope that helps.
Regards,
Brandon
12-02-2014 05:40 AM
Thanks ..
But i want to select particular ap and ssid ....
12-02-2014 06:29 AM
Hi Prasan,
Revisiting this issue, if you have your APs assigned to specific campus/building for your company, you can drill down to the specific AP and SSID that you want for that client count. The options that I used to run a report for one AP for one location that we have is as follows:
report title: <enter applicable name for report>
report by: AP by floor area
report criteria: choose edit and search for the location/building/campus and then the specific AP that you want from those fields. Then choose select.
Once back at the report screen you can set the next options:
connection protocol: select from drop down what you want if it is all clients, all wireless, etc.
The next drop down should allow you to select the specific SSID to what you want based upon the individual AP. Followed by the report time afterward. This report will output as a line graph showing the total number of clients based upon your search criteria and time frame. If you want to research client counts and see their mac address and IP ranges then you are limited to only seeing the current associated clients from the operation > work center flow while viewing the specific AP. Hope that helps.
Regards,
Brandon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide