Prime Infrastructure and VM

[dapgar]

Please advise on the following for my Prime Infrastucture on a VM:

VM Hardware Compatibility

Upgrade Available

On VM: ESXi5.1 and later (version 9)

On Host: ESXi 6.7 and later (Version 14)

Upgrade to match Host

Can this upgrade be done with out causing interference with the nodes in production?

Thanks

[Marvin Rhoads]

Your question is very unclear.

What is your current version? Do you want to upgrade and migrate to a new ESXi server?

[dapgar]

On VM:  ESXi 5.1

On Host: ESXi 6.7

So can we upgrade the VM to 6.7 without uninstalling Prime Infrastructure, ISE-PAN, ISE-MandT, and ISE-PSA1 and 2?

That is the question that I am referring to in both of my community posts.

Thanks

David

[Marvin Rhoads]

What is your Prime Infrastructure version?

[dapgar]

Version 3.2

[dapgar]

Version 3.2 for Prime Infrastructure

[Marvin Rhoads · Accepted solution]

It may work but you would be better to upgrade. Depending on how you are using your Prime, it may be easier to just export your devices and import into a fresh installation of 3.8 running on ESXi 6.7. You can backup and restore but that's a lot more complicated and takes much longer.

The officially supported ESXi versions for Prime Infrastructure 3.2 are 5.5 and 6.0.

https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-2/quickstart/guide/cpi_qsg.html#pgfId-138947

Prime Infrastructure 3.6 and above (the current release is 3.8) support ESXi 6.7:

https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-6/quickstart/guide/bk_Cisco_Prime_Infrastructure_3_6_0_Quick_Start_guide.html#con_1070036

[dapgar]

Thank you Marvin.

I also have the same question for ISE, we have 4 VM's in the following configuration: 1 PAN, 1 M&T and 2 PSA's.
Can they run ESXi 6.7?

Thanks again for your assistance