09-09-2014 10:37 AM
Primes are supposed to be installed in 2 different servers: 1 primary, 1 secondary for redundancy.
However, the second Prime was accidentally installed as a stand alone server. Hence, it could not register with the primary one.
May I know if there is any way or any command to switch the second Prime from stand alone to secondary in HA mode. Or I need to reinstall Prime from the OVA file?
Solved! Go to Solution.
09-09-2014 03:52 PM
The supported method is to specify the role during installation. (Reference)
You might be able to re-initialize the db and re-run setup but I would strongly advise restarting with a clean installation to maximize your probability of success.
09-09-2014 03:52 PM
The supported method is to specify the role during installation. (Reference)
You might be able to re-initialize the db and re-run setup but I would strongly advise restarting with a clean installation to maximize your probability of success.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide