Prime infrastructure config report

[KacyHicks21882]

I want to see a output report from sending the command show run | i snmp to a group of devices Is it possible to use PI to produce a report of the output from specific devices when a command is sent?

[balaji.bandi]

may be try below  :

https://www.cisco.com/c/dam/en_us/training-events/product-training/prime-infrastructure-32/PI32_Audit/PI32_AuditingDeviceConfigurations.pdf

[Flavio Miranda]

Hi

 Do you want to run the command "show run | i snmp" and you want to see the output of this command in a Prime report?

I dont think is possible. Report generated by Prime is based on snmp raw data collected from devices and I dont believe this information could be gathered using snmp.

[iportuga]

Hi,

You might use the REST API CLI Template endpoints, to create, deploy a CLI template to run it to target list of devices, then collect the CLI ouput outcome in the job result.

Take a look:
https://developer.cisco.com/site/prime-infrastructure/documents/api-reference/rest-api-v3-9/
https://developer.cisco.com/site/prime-infrastructure/documents/api-reference/rest-api-v3-9/v4/op/cliTemplateConfiguration/deployTemplateThroughJob-PUT@_docs/

[KacyHicks21882]

Those links are either not available us or have been moved.