Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our colab servers are running on a vm hardware that needs maintenance and we need to shut it down, during this time we would also like to change our TLS min version to 1.2. Is it possible to set the minimum TLS version and have a server shutdown inst...
We are using Jabber phone services in a conference room were a user uses a hearing aide. The user has a hard time hearing the speakers from the camera/speaker/mic system and we added a JBL charge 5 bluetooth speaker (no microphone) so he could hear ...
I want to see a output report from sending the command show run | i snmp to a group of devices Is it possible to use PI to produce a report of the output from specific devices when a command is sent?
We are running CPI 3.9.1 and would like to add details to the message body of the alerts that are not appearing. I have not found how to modify them in CPI, the only thing I found searching is a ten year old post asking the same thing here and being ...
You are not blind. I have confirmed this with Umbrella, why it wasn't thought of is mind boggling. I had the technician put in a feature request for this years ago, I recommend everyone start doing this also.
Roger Kallbe & Nithin Eluvathinga this is not possible as when you enter set min tls 1.2 it states the system will be restarted do you accept? y/n if you decline the is the change applied? If you accept the system makes the changes and starts the res...
Just got this from TAC for the CSC 5.x may help others.Secure Client is not supported on ASA versions older than 9.14. If you want to continue using remote access VPN, you will need newer hardware.”https://www.cisco.com/c/en/us/td/docs/security/asa/c...
These were the last responses I received from TAC before the ticket was closed. Hello, The default value of msie-proxy lockdown is enabled by default, it is not in the CLI config as it is not manually set.You should be able to change it from ASDM as ...
