Prime Infrastructure Unable to Archive Configurations

[teja.vemula]

I have a issue with the Prime Infrastructure. We upgraded our PI recently and after upgrading it to " 3.4.0.0.348" I do not see configurations archiving in Inventory--> Configuration Archive--> Latest Archive Date is 8/16. But I see in Administration--> Job Dash Board--> Configuration Archive, jobs are running everyday.  
Please help.  
Thank you, Teja.

[varusrin]

Hi Teja

Is it with all devices or a particular device type?

Also, are the config archive jobs completed successfully?

Can you share screenshot from Inventory>Device>Configuration Archive Tab?

Regards,

Varun Iyer S

[teja.vemula]

Hi Varun,

Thank you for your reply.

1. Yes, it is with all devices types

2. Partial success due to few devices are unreachable and few are not unsupported.

3. Attached are the screenshots.

[varusrin · Accepted solution]

HI Teja

For the devices which don't have any configuration changes,

PI will not save the newly collected Config Archive and the Timestamp shown will be older date.

Its an expected behaviour.

To test this you can make a config change, for example Interface Description and run the Config Archive Job.

Regards,

Varun Iyer S

[teja.vemula]

Hi Varun,

I think you are correct. I did some interface changes on the few switches and ran archive job and now I see date has changed on the Last Archive Tab.

But previously when I was on old code, even though if there were No configuration changes, I was still able to see Last Archive Tab date changes everyday. 

So now this is something new. Is it because of the code change?

Thank you,

Teja.

[varusrin]

Hi Teja

The behaviour is same from past 3-4 versions.

Regards,

Varun Iyer S

[teja.vemula]

Thanks Varun. I appreciate your help.

[Rasika Nayanajith]

Hi Teja,

I have a similar setup, I will test it & let you know

Rasika