05-19-2016 09:28 AM
we are starting a project to assign privilege level to groups but not understanding how this works. Are there pre-assigned privileges to each level and what are they? Here is what we would like to do but we found that you cant overlap privileges. Level 3 - sho run and sho interface. Level 5 - sho run, conf t, interface changes, shut, no shut, desc, wr mem. Level 15 - all rights. how do we give two different .levels some of the same privileges?
05-19-2016 10:31 AM
Hi,
as far as I am aware, higher level privilege levels have the commands from under it automatically,
so if level 3 should have show run and show interface then level 5 also gets that as well as the commands you are adding to level 5.
There are a few commands that are standard for level 1, then I think the rest are at level 15 unless you are changing something.
05-19-2016 10:36 AM
thanks that helps a lot. Much appreciated.
05-19-2016 10:40 AM
You are welcome :)
Please rate helpful responses and close the thread.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide