08-06-2015 01:17 PM
Hi Guys,
We have a Customer that try to monitore active call in E1 interface in voice gateways. Two months ago the Cisco inform to me that the OID below could be this activity.
cpmDS1ActiveDS0s (.1.3.6.1.4.1.9.10.19.1.1.9.1.3)
The number of DS0s that are currently in use for a particular DS1
The Customer configured 20 E1´s interfaces, but, the monitore is showing only 4 E1´s
Vendor Management: Cacti
Version: Version 0.8.7e
Are there limitation to monitore device by OID?
Any have idea about this?
Thanks,
Wilson
08-06-2015 04:44 PM
Hi Wilson,
Could it be possible to have an output of a snmp walk using 1.3.6.1.2.1.2.2.1?
It will display the current interfaces on such device via snmp.
Regards,
Ernesto Q
01-04-2016 07:40 PM
Hi,
I would like to verify if what are the needed configurations in the voice gateway when we want to monitor the E1 by integrating it to Solarwinds? Do we need snmp configurations only, Right?
or we need to configure also IP SLA configurations?
Thanks guys.
01-05-2016 03:07 AM
Hi ccg-collab1,
I am not specialist in SNMP comunity, but, when my Customer did the configuration he used only snmp conifguration.
I wait have help
Thanks,
Wilson
01-11-2016 11:39 PM
May i know what are the snmp configurations you added in the voice gateway? Thanks
01-12-2016 02:04 AM
Hi ccg-collab1,
The Customer added only snmp <name> RO, only (Not was necessary used a specific SNMP)
Wilson
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide