09-06-2010 05:41 PM
is it possible to erase all database entries and start from scratch or
should I do a re-install of my existing LMS 2.6 and start fresh.
I started without a clear idea of what I was going to do and now I have a clear idea
but a system that is in a bit of a mess
Solved! Go to Solution.
09-07-2010 11:33 AM
Yes, check out the dbRestoreOrig utility described at the URL below.
For example, to reset RME data to the default: /opt/CSCOpx/bin/perl /opt/CSCOpx/bin/dbRestoreOrig.pl dsn=rmeng dmprefix=RME
However, I'd certainly entertain the option of reinstalling LMS 2.6 as well.
09-07-2010 11:33 AM
Yes, check out the dbRestoreOrig utility described at the URL below.
For example, to reset RME data to the default: /opt/CSCOpx/bin/perl /opt/CSCOpx/bin/dbRestoreOrig.pl dsn=rmeng dmprefix=RME
However, I'd certainly entertain the option of reinstalling LMS 2.6 as well.
09-12-2010 04:09 PM
That actually did the job quite well, some bits I had to go in adjust later
but the system is in a better state then previously
thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide