PXE boot service not running via Cisco ISE

[Prashobcv93]

PXE boot service not running via Cisco ISE.

When we use PXE boot loader option, it shows 'Start PXE over IPv4 on MAC' but it disconnects/doesn't load and no action is done.

Could anyone help me in this?

[Prashobcv93]

Following is the switch port configuration:

Building configuration...

Current configuration : 630 bytes
!
interface GigabitEthernet2/0/42
description *** Build Port ***
switchport access vlan 140
switchport mode access
authentication event fail action next-method
authentication host-mode multi-auth
authentication open
authentication order dot1x mab
authentication priority dot1x mab
authentication port-control auto
authentication periodic
authentication timer reauthenticate server
authentication timer inactivity server dynamic
authentication violation protect
mab
dot1x pae authenticator
dot1x timeout tx-period 10
spanning-tree portfast
spanning-tree bpduguard enable
service-policy input ACCESS-INGRESS
end

[balaji.bandi]

what mode of deployment and what ISE version  - check below thread to start with:

https://community.cisco.com/t5/network-access-control/cisco-ise-closed-mode-pxe-use-case/td-p/3528335

[Prashobcv93]

[Prashobcv93]

How to check the deployment mode from Web UI?

I am new to ISE and need some help with the checks.