ā07-01-2024 06:40 AM
We have a DC with multiple sites connected via MPLS. On the DC router, we have two MPLS circuits:
- Primary circuit (2Gig)
- Secondary circuit (1Gig)
We also have two QoS policies on the Hub router, each tied to a specific circuit:
- QoS-2Gig (for the 2Gig primary circuit)
- QoS-1Gig (for the 1Gig secondary circuit)
We need to configure QoS on the spoke routers to support both MPLS circuits. If the primary circuit (2Gig) goes down, the spoke routers should automatically switch to the secondary QoS policy (QoS-1Gig).
Please provide guidance on how to configure QoS on the spoke routers to achieve this setup.
Thank you.
ā07-01-2024 07:51 AM
Traffic migration to a lessor bandwidth path is usually provided by routing, not QoS. (I suspect there's much room for possible QoS discussion, but I'll leave to you to open that subject.)
Is the issue, at remote sites they only have one WAN physical interface?
ā07-01-2024 08:02 AM
Thank you Joseph for your response, yes this is the problem that remote sites only have one WAN interface
ā07-01-2024 09:08 AM
So what, exactly, do the remote sites "see"? For example, do they "see" HQ's two (2g and 1g interfaces) IPs in the same subnet?
What are you using for a routing?
ā07-01-2024 12:55 PM
two cases so close is open this week
for your case you can use EEM and IP SLA
detect if Hub use primary link apply QoS for 2 G
if IP SLA detect hub use secondary then apply QoS for 1 G.
in DMVPN the hub can push the QoS via tunnel but I dont think you use DMVPN over MPLS
MHM
ā07-01-2024 01:32 PM
Thank you MHM cisco world, can we apply two QoS policies in the same interface for spoke routers ?
Do you have any configuration example please?
ā07-01-2024 01:36 PM
you can not two only one but by using EEM we can exchange one QoS with other depend on status of IP SLA
MHM
ā07-01-2024 01:43 PM
please do you have a config sample ?
ā07-02-2024 06:45 AM
yes we use DMVPN
ā07-02-2024 06:49 AM
that better friend
I was start run lab for mpls only but with new info you use DMVPN you can Per-Tunnel QoS DMVPN feature
MHM
ā07-02-2024 07:37 AM
thank you much MHM
ā07-02-2024 07:42 AM
now we have 1 tunnel between the hub and spokes , do we need to create another tunnel for the secondary circuit ?
ā07-03-2024 06:10 AM
Yes friend you need two tunnel in hub and spoke because it simple can not have two interface have same IP in one device
below example how you can config two tunnel in hub using one ISP and two tunnel in spoke using two ISP
MHM
ā07-03-2024 07:33 AM
Thank you MHM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide