"memory allocation failed" when configuring NetFlow with SCTP
After I configured a 2811 router with "ip flow-export destination 10.10.100.100 9995 sctp", the router showed errors of "%SYS-2-MALLOCFAIL: Memory allocation of 1708 bytes failed from 0x40394258, alignment 32, Pool: I/O Free: 480 Cause: Not enough free memory". After that OSPF adjacency came down and router became non-responding. Here is the complete NetFlow config:
ip flow-export source Loopback0
ip flow-export version 9
ip flow-export destination 10.10.100.100 9995 sctp
backup destination 10.10.100.101 9995
backup mode fail-over
Does "ip flow-export sctp" command have memory requirement? I searched Cisco command reference but didn't see any. Have anyone seen similar errors on other router platforms or IOS? I'm running IOS 12.4(24)T2 advanced enterprise.
Hello guys.I installed remote access VPN on Windows 2019. I need to do additional configuration on the router to allow access outside. I got this.Public IP--------------ISP Router-------------Fa0/0 Cisco Router Fa0/1------------------------My Server ...
Meet the Authors video - How to Troubleshoot Network Problems with Vinit Jain
(Live event – Wednesday, February 12th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event had place on Wednesday 12th, February 2020 at 10hrs PDT&nbs...
I have a pair of 3945 routers that are proving to be underpowered for the 100+ remote offices connecting to them. Fortunately I happen to have a couple of 4351 ISRs rated for significantly greater encrypted throughput. Is there any way I could upgrade the...
This article assumes you have the basic knowledge and experience with Cisco DNA Center and Identity Services Engine (ISE).Note when reading this doc the "Authentication Policy" referred to is part of Cisco DNA Center Onboarding section and ha...