Network Management

Hello,I want to ask 3 questions about data migration from LMS to PI1.2 as the virtual marketing synonym for the real existing product NCS1.2:1. Is there a real working and relyable data migration from LMS to PI1.2(NCS)?2. What is the minimum LMS vers...

Hello,I have a Catalyst 6509-E-VSS with IOS 12.2(33)SXI3.I'm looking for OIDs to retrieve the same counters I get with the commands"show interface stats" and "show interface switching".I want to graph the number of packets that are process switched.T...

Hello to everyone,might sound strange but i´m looking for two hours now and can not find a way to suspend a device in the Fault Monitor. We´re using LMS 4.2.2Can someone point me to the right direction? Thank you.Regards,Chris

I need to config a new 891 to allow access to all users, to access XBOX live. Im unable to get the NAT below moderate or route to more than one internal address.                  

Hi all,i am trying to find the link saturation using OLD-CISCO-INTERFACES-MIB locIfLoad. I see that this counter is now deprecated. The replacement MIB supposed to be IF-MIB and CISCO-QUEUE-MIB. I couldn't figure out the way to find link saturation w...

Hi We are looking for some free or cheap software to use on a customers network that will enable us to scan or see the network and what packets are being sent on it. We install business VOIP phones and phone systems and we get a lot of calls saying c...

Hi all, the customer has CUCM in the inventory database of LMS 4.1. He has all accesses from LMS to CUCM. One phone 7961 is seen in the UT report. When the customer click on the CUCM in the inventory - there is no IP phone registered in the CUCM. Wha...

If I am simply running a TCL script every 10 seconds, how can I store varilable info between the TCL script runnings?  I have tried:+ Writing the info to an EEM Variable in the Sho-Run, and then reading in this info each time the script runs, and the...

Hi all, the customer has CUCM in the inventory database of LMS 4.1. He has all accesses from LMS to CUCM. One phone 7961 is seen in the UT report. When the customer click on the CUCM in the inventory - there is no IP phone registered in the CUCM. Wha...

We have a LMS 4.2 installed. And I see the tftp port is open on it. however, every time, i tried to "copy running tftp" to the LMS from a switch, it says the Trying to connect to tftp server......Connection to Server Established.TFTP put operation fa...

Hi,I've recently installed two 3750V2 stacks int o our network.I tried to see them via ciscoview, but it show me an empty chassis shape with "Unkown Device" written inside.I updated every ciscoview package into CS >Software Center > Device Updates.Bu...