RME database update after upgrade to 12.2.53SG2 (cat4510 sup6e)

[jabouaf]

Hello,

I use LMS3.1

After some cat4510 (with sup6-e) were upgraded to 12.2.53SG2, then LMS does not discover/inderstand that the IOS release was changed.

A quick look at bug for IOS  cat4500 12.2.53SG2 / LMS show nothing.

Does someone have some idear ?

I don't want to remove those switches from CS database to keep all previous configuration changes.

doing a snmp check on oid sysname (from device center) is ok.

credential test is ok.

regards,

[Gaganjeet Chug]

Hi,

Ciscoworks update the information about the IOS changes on the device through Inventory Collection via SNMP. If the SNMP credentials are OK, kindly try to run the Inventory collection for this device from Device Centre for this device and see if the Inventory collection job is successfull.

Thanks,

Gaganjeet

[jabouaf]

Hello Gaganjeet,

I already done an inventory update, and also an discoevry of all equipment. But this not better.

Is there a way to not check the copact flash ?

I just find now that I have some syslog message about a compact flash that doesn't exist.

I guess that those messages appears when there is an snmp polling.

syslog message

"%C4K_FLASH-4-COMPACTFLASHNOTREADY: Compact flash is not ready"

regards,