Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
802
Views
0
Helpful
1
Replies

ROSA element manager enquiry ( connection using RS 232 interface )

Mohamad12345
Level 1
Level 1

‎10-14-2011 12:23 AM

Hi , I'm RF transmission engineer working in broadcast  station .

Our broadcast transmitters have only serial RS 232 interfaces .

We have ROSA element maanger unit in our site so i need to connect the broadcast transmitters to the ROSA element manager .

How can i do that ?

After finishing all installation is it possible to communicate with the broadcast equipements using web browser from our LAN ?

Labels:
0 Helpful
1 Reply 1

Michel Hegeraat
Level 7
Level 7

‎10-15-2011 09:02 AM

It would appear that if the ROSA supports your type of equipment then it would allow you to manage or at least monitor the device using a web browser.

This would mean that the ROSA hes a very good knowledge of how your equipment works and what questions or instructions it can give via the serial connection.

I have a very limited trust in general of this sort of equipment. Make sure you exact devicetype has support from cisco with its current software.

Cheers,

Michel

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card