08-01-2020 09:09 AM
could someone please confirm if RSPAN will work with the below config for capturing traffic from vlan 5-6 on both switches?
SW2
!
monitor session 1 source vlan 5 - 6
monitor session 1 destination remote vlan 99
SW1
!
monitor session 1 source vlan 5 - 6
monitor session 1 destination remote vlan 99
monitor session 2 destination interface Fa0/45 - 46
monitor session 2 source remote vlan 99
!
server for capturing traffic is connected on sw01 port 45-46. RSPAN from sw02 is working. but we're unable to see traffic for vlan 5 from sw01.
vlan configuration, allowing vlan in uplink are already in place. is this configuration correct?
we saw that we cannot use same destination port for two sessions
but here, we're passing the traffic from session 1 to 2. And then only pointed towards destination ports.. will this also be considered as two sessions?
Solved! Go to Solution.
08-03-2020 05:06 AM
Yes I did.. I found the below useful for this case
08-01-2020 02:55 PM
Have you configured the remote span vlan on both and with remote-span command on vlan?
08-03-2020 05:06 AM
Yes I did.. I found the below useful for this case
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide