04-01-2013 12:50 PM
Good afternoon.
I need a tool simulator or emulator for my work, because before a change first i would have to configure in tool and before I configure in the production environment, I have 4506 e-series, catalyst 2760, catalyst 2960 and We need a simulator or emulator that can me configure whit those devices.
Who can a tool that can me to do this??'
Best regards
Jhoanna
04-02-2013 04:33 AM
Hello,
Try GNS3
hope that helps
Regards
Please rate all usefull posts and dont forget to close solved questions.
04-02-2013 07:44 AM
Thanks Riyaaz but with GNS3 I can't simulate the devices that I described in the previous post, i need a tool that I can emulate these devices
04-02-2013 06:22 AM
For the equipment you listed there are no simulators. You'll have to purchase the hardware for your test lab.
04-02-2013 07:46 AM
My institution don't have money to buy the same devices to test environment, and I need some tool because we have to have a tool to first configure the new updates or changes in the simulator o emulator and after run the changes in the production environment.
04-02-2013 08:48 AM
That's a management call at this point. They either have to purchase the gear so you can test config deployment or they can choose not to spend the money and take the risk of misconfiguration during the change. There are no simulators.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide