cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2194
Views
0
Helpful
1
Replies

SNMP and Logs events

Hello All

Does anybody have a idea how to supress snmp and log events of a isdn pri interface, because I´ve executed the Cisco commands recomendation on the interface but doesn´t work because the NMS still recive a lot of snmp events of these pri interfaces:

The enviroment:

controller E1 1/1/0

framing NO-CRC4

pri-group timeslots 1-31

Serial1/1/0:0 unassigned YES unset up up

Serial1/1/0:1 unassigned YES unset up up

Serial1/1/0:2 unassigned YES unset up up

Serial1/1/0:3 unassigned YES unset up up

Serial1/1/0:4 unassigned YES unset up up

Serial1/1/0:5 unassigned YES unset up up

Serial1/1/0:6 unassigned YES unset up up

Serial1/1/0:7 unassigned YES unset up up

Serial1/1/0:8 unassigned YES unset up up

Serial1/1/0:9 unassigned YES unset up up

Serial1/1/0:10 unassigned YES unset up up

Serial1/1/0:11 unassigned YES unset up up

Serial1/1/0:12 unassigned YES unset up up

Serial1/1/0:13 unassigned YES unset up up

Serial1/1/0:14 unassigned YES unset up up

Serial1/1/0:15 xx.xx.xx.xx YES TFTP up up

Serial1/1/0:16 unassigned YES unset up up

Serial1/1/0:17 unassigned YES unset up up

Serial1/1/0:18 unassigned YES unset up down

Serial1/1/0:19 unassigned YES unset up up

Serial1/1/0:20 unassigned YES unset up down

Serial1/1/0:21 unassigned YES unset up up

Serial1/1/0:22 unassigned YES unset up up

Serial1/1/0:23 unassigned YES unset up up

Serial1/1/0:24 unassigned YES unset up up

Serial1/1/0:25 unassigned YES unset down down

Serial1/1/0:26 unassigned YES unset up up

Serial1/1/0:27 unassigned YES unset up up

Serial1/1/0:28 unassigned YES unset up up

Serial1/1/0:29 unassigned YES unset up up

Serial1/1/0:30 unassigned YES unset up up

interface Serial1/1/0:15

ip unnumbered Loopback0

ip access-group 140 in

ip nat outside

ip rip advertise 1

encapsulation ppp

no logging event link-status

no snmp trap link-status

dialer mult-map-same-name

dialer-group 1

isdn switch-type primary-net5

peer default ip address pool xxx

no cdp enable

ppp ipcp ignore-map

end

Thanks in advance

Marcelo

1 Reply 1

murabi
Level 4
Level 4

SNMP link notifications are sent when an interface goes up or down. For interfaces expected to go up and down during normal usage, such as ISDN interfaces, the output generated by these notifications may not be useful. Use the no snmp trap link-status interface configuration command to disable these notifications.

Review Cisco Networking for a $25 gift card