Hello All
Does anybody have a idea how to supress snmp and log events of a isdn pri interface, because I´ve executed the Cisco commands recomendation on the interface but doesn´t work because the NMS still recive a lot of snmp events of these pri interfaces:
The enviroment:
controller E1 1/1/0
framing NO-CRC4
pri-group timeslots 1-31
Serial1/1/0:0 unassigned YES unset up up
Serial1/1/0:1 unassigned YES unset up up
Serial1/1/0:2 unassigned YES unset up up
Serial1/1/0:3 unassigned YES unset up up
Serial1/1/0:4 unassigned YES unset up up
Serial1/1/0:5 unassigned YES unset up up
Serial1/1/0:6 unassigned YES unset up up
Serial1/1/0:7 unassigned YES unset up up
Serial1/1/0:8 unassigned YES unset up up
Serial1/1/0:9 unassigned YES unset up up
Serial1/1/0:10 unassigned YES unset up up
Serial1/1/0:11 unassigned YES unset up up
Serial1/1/0:12 unassigned YES unset up up
Serial1/1/0:13 unassigned YES unset up up
Serial1/1/0:14 unassigned YES unset up up
Serial1/1/0:15 xx.xx.xx.xx YES TFTP up up
Serial1/1/0:16 unassigned YES unset up up
Serial1/1/0:17 unassigned YES unset up up
Serial1/1/0:18 unassigned YES unset up down
Serial1/1/0:19 unassigned YES unset up up
Serial1/1/0:20 unassigned YES unset up down
Serial1/1/0:21 unassigned YES unset up up
Serial1/1/0:22 unassigned YES unset up up
Serial1/1/0:23 unassigned YES unset up up
Serial1/1/0:24 unassigned YES unset up up
Serial1/1/0:25 unassigned YES unset down down
Serial1/1/0:26 unassigned YES unset up up
Serial1/1/0:27 unassigned YES unset up up
Serial1/1/0:28 unassigned YES unset up up
Serial1/1/0:29 unassigned YES unset up up
Serial1/1/0:30 unassigned YES unset up up
interface Serial1/1/0:15
ip unnumbered Loopback0
ip access-group 140 in
ip nat outside
ip rip advertise 1
encapsulation ppp
no logging event link-status
no snmp trap link-status
dialer mult-map-same-name
dialer-group 1
isdn switch-type primary-net5
peer default ip address pool xxx
no cdp enable
ppp ipcp ignore-map
end
Thanks in advance
Marcelo
