cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1128
Views
0
Helpful
4
Replies

SNMP monitoring of stack RPS

Petr Nyvlt
Beginner
Beginner

Hello everybody,

I need to monitor status of RPS of stack switches.

I have found this OID  chassisPs2Status 1.3.6.1.4.1.9.5.1.2.7

http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?local=en&translate=Translate&objectInput=1.3.6.1.4.1.9.5.1.2.7

It returns 2 when OK, 4 in case of failure, but it works only for master switch in stack. It doesn´t change when RPS of member switch fail.

SW  Status          RPS Name          RPS Serial#  RPS Port#

--  -------------   ----------------  -----------  ---------

1   Active          <>

2   Standby         <>

It still return 2 as OK

Is there some OID for stack members? In case of stack of 9 switches they cannot be backed up by one RPS and we need to monitor it's RPS status.

4 Replies 4

AFROJ AHMAD
Cisco Employee
Cisco Employee

Hi Petr,

When monitoring the status of the PS's on the master you should be able to get the
information about the slaves as well.

You can also use the CISCO-ENVMON-MIB which contain two OIDs to fulfill your purpose:

1)  .1.3.6.1.4.1.9.9.13.1.5

2)  .1.3.6.1.4.1.9.9.13.1.5.1.4

Thanks-
Afroz
[Do rate the useful post]
****Ratings Encourages Contributors ****

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****